• 2-1-SPORT-Fitnessbaender
  • 2-2-SPORT-Rubberbaender
  • 2-3-SPORT-Tubes
  • 3-1-SPORT-Thermokissen
  • 3-2-SPORT-Taschenheizkissen
  • 1-Tens-Ge-240-454b1e038f
  • 2-Tens-Ge-250-516302449c
  • 4-Tens-Zu-Ruecken
  • 5-Tens-Zu-Knie
  • 6-Tens-Zu-Nacken
  • 7-Tens-Zu-Elektrode-2
  • 8-Tens-Zu-Elektrode-3
  • 2-1-Kinesio-Ro-Tuerkis
  • 2-2-Kinesio-Ro-Pink
  • 2-3-Kinesio-Ro-Beige
  • 2-4-Kinesio-Ro-Schwarz
  • 2-5-Kinesio-Ro-Blau
  • 2-6-Kinesio-Ro-Gruen
  • 2-7-Kinesio-Ro-Rot
  • 3-1-Kinesio-So-Schere
  • 1-1-Bandage-St-Ruecken
  • 1-2-Bandage-St-Knie
  • 1-3-Bandage-St-Ellenbogen
  • 1-4-Bandage-St-Fuss
  • 1-5-Bandage-St-Hand
  • 1-Thermo-DSO
  • 2-Thermo-FTM
  • DET-306_02
  • 1-1-Therapie-So-Inhaler
  • 1-3-Therapie-So-Shiatsu
  • 1-4-Therapie-So-Diabetiker

FAQ: TEN 240

TEN 240

For which type of stimulation can I use the TEN 240?

The TEN 240 is intended to be used for TENS therapy. To this end, an electric current is transmitted
through the skin and the nerve pathways are stimulated electrically.

Can the TENS programs be adjusted to my individual needs?

The TEN 240 does not have adjustable programs. All 13 programs are permanently programmed.

How can I detect a cable break in the TENS device TEN 240?

Example: Does channel 1 not function properly and not emit an output impulse?
There might be a cable break. Please test this cable again on channel 2 to rule out this fault. If there is still no output impulse afterwards, please contact our service centre.

Why do the adhesive electrodes not lie properly on the skin?

- Please clean your skin before using the product. Any residues on the skin, e.g. from creams or sweat, impair the adhesive strength of the pads.
- Re-position the adhesive electrodes.
- If the adhesive electrodes are worn out, you can re-order them from the following shops: www.fit-und-aktiv24.de or www.insmedshop.de

Why does the program application of the device switch off after 15 minutes?

The minimum period for each therapy session is 15 minutes. The application time settings can be found on page 13 of the instruction manual.

Why can the TENS device be switched up to intensity level 10 and then falls back to level 0?

The adhesive electrodes must lie completely flat against the skin. If this is not the case, the electric circuit is interrupted and the device automatically switches back to intensity level 0 for safety reasons.

In the instruction manual, I cannot find an example of how to apply the device on the knee. Which program should I use?

Each program can generally be used on the body.
We recommend using program 4 + 10. To do this, position the adhesive electrodes as follows:
1st channel: Adhesive electrode approx. 5 cm above and below the kneecap
2nd channel: Adhesive electrode approx. 5 cm to the right and left of the kneecap

Where can I obtain an instruction manual?

The instruction manual available for download can be found on our homepage.

Select Service -> Manuals